Answer Posted / guest

Excuse me if my answer is wrong......

Electrical Interlock- It is the interlocking of two
incoming power supply by using electrical equipments like
relays.
Consider we have two power supply viz, EB and DG supply.If
EB supply cut,DG will run and viceversa.By mistake whether
both EB and DG supply is ON, it will make hazardous action
to our panels.At that time that relay will sense and make
NO,NC changes and allow only one supply pass through our
loads.

Mechanical Interlock- It is the interlock between two power
supply by using Key System.
There are two locks and one key. If we want to switch ON EB
power, first we have to lock DG power and remove the key
from DG lock and then we can switch ON EB supply and
viceversa.

We have 250 KW x 2 motors, which are load from 25% to 100% varying load in every minute , so how can we compansate the power factor. pl give your opinions on the above subject.

1416

---

What is corkscrew rule?

679

---

what parameters are should nessary for control technic dc drive(in rolling mills)?

1508

---

define as synchronous generator

1688

---

What is the source of dependent source ?

1425

---

---

I HAVE BEEN SELECTED FOR APGENCO A.E(ELECTRICAL) 2008.HOW MUCH WEIGHTAGE FOR INTERVIEW AND WRITTEN TEST.HOW I HAVE TO PREPARE. PLEASE GIVE INFORMATION IF U KNOW.WHAT ABT G.D THIS TIME.CALL RATIO 1:2

2419

---

What is the Minimum winding resistance of motors ( small & big)? referance range

1843

---

What will happen to the protection and metering, if the polarity of a single or two PT/PTs in three phase system is reversed? Please provide reference if any.

1716

---

Hello Friends, How can we recognize the CT Star Point is S1 or S2 in case of Electro Mechanical Relays and what is meant by Restraining coil in relays and what is the purpose of that.. thank you in advance..

1675

---

- two pumps must work with them at the same time but if the first pump start the second pump  must delayed for some time to start  also , with motor rated power = 90 KW and rated voltage = 380 V and rated power factor = 0.85 lag please draw the power and control circuit for it and determine all circuit components parameters that you use it

2227

---

What is turn ratio of a transformer?

662

---

while doing high voltage test on 11kv/433 distribution transformer why we only give 28 kv on hv side and 3kv on lv side for power transformers what is the value what factors it depends

2368

---

i have attended the interview on 4th June,08 at Kolkata in IOCL, can anybody tell me what is its result

1548

---

how can we save enegry by using VFD for Resiprocating Air compressor which is having more unloading running hours

1787

---

sir, I am from EEE branch.On feb 17 iam going to write an Exam for hindustan petrolium corporation Ltd.So plz send me the written exam pattern/Q's/interview questions.please mail to eee_dharmendra@yahoo.com

1400

---