Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / satya dev ( knight frank)
Main Parts- Stator,Rotor, Diode, windings, Pick up unit
Safety parts- AVR, CTs & PTs,
Movable Parts- Shaft,Cooling wheel,
| Is This Answer Correct ? | 20 Yes | 7 No |
Post New Answer View All Answers
Why do we use copper cable for HT Supply and why not Aluminium?
how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.
What is the diff. between single compression and double compression gland
what is negative d.c. voltage, why this voltage is used in base transciever station.
Why Neutral Isolation is required?
what is meant by 3rd hormonics ?
why booster transformer is used in sumpners test conducted on transformer????
What is the role of feedback in a closed loop control system?
HOW DO YOU CAN CHECK A 15KV DIODE, WHETHER IT IS OK OR NOT?
How to calculate the no of Ceiling fan (1200mm sweep) per unit area?
How to calculate cable rating for 3 phase supply?
How to Calculate The Neutral Earth flat design calculation for the Synchronised generator (Gen 1-650Kva, Gen 2-725Kva
ANY ONE TELL ME ABOUT generator synchronization panel panel to synchronise 3 gen of 250kva both automatic and manual. 2 gen output vol 415 3ph, 1 gen output vol 400 3ph SEND THE DETAILS DIAGRAM ON THIS EMAIL ADDRESS ayazleo@hotmail.com as soon as possilble best ragrds electrical engineer ayaz mahmood SAUDI TECH
Hello Friends, How can we recognize the CT Star Point is S1 or S2 in case of Electro Mechanical Relays and what is meant by Restraining coil in relays and what is the purpose of that.. thank you in advance..
why we use single core 630mm2 cable for transformer secondary side
