Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / anurag,e&a,ispat ind. ltd.
loop is that by which we feedback some output signal to
input.there are two type of loops.
1.closed loop
2.open loop
| Is This Answer Correct ? | 18 Yes | 1 No |
Post New Answer View All Answers
Explain working principle of lvdt?
Why thermo wells are used? What materials are used in thermo wells?
What is Droop? What is Step/Gradient Limiter in Turbine Governor control?
Tell about your IFFCO plant visit.
why direct mounted pressure transmitters is always installed with DBB ( double bleed block) valve in process line or top of the tanks ?
what is orfics working in main steam line. is it increase pressure, velocity of steam flow and dicrease steam flow rate. or any other
1.what is controller proportional gain 2.what is the controller intergral action time. 3.A proportional plus derivative controller that has a proportional band of 20% and a derivative action time of 0.1 minutes. Construct the shape of the output waveform for the triangular input if the input rises and falls at the rate of 4 units per minute.
What are the uses of orifice plates?
Why boiler chimney area oxyden sensor fixing?
Type of level transmitter commnly used in Procees area are the following. a.________________This type of level transmitter works as follows
please send me some question papers of HPCL aptitude test ?? please send it to bipinb.28@gmail.com ...
Can u tell me the principle of the tc,rtd,level switch,pressure switch ,transmitter(pr flow level temp.),vibration...plz
Why flow/pressure transmitter before control valve?
Why all the drains(Gland sealing,ESV,Casing inlet etc) are directly connected to the flash tank instead of hotwell of the condensor in the power plant? My Email Id:naba02222@gmail.com
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
