Interested to Buy Any Domain ? << Click Here >> for more details...
What are difference between automatic and manual control system?
- 5 Answers
- 58851 Views
- I also Faced
- E-Mail Answers
Answer Posted / anurag,e&a ispat ind. ltd.
in manual control system all the controlling parameter have
been controlled by operatorbut automatic control system all
parameter are controlled by automatic control system by
using plc,dcs @scada system.
| Is This Answer Correct ? | 92 Yes | 8 No |
Post New Answer View All Answers
How to Calibrate Coriolis Flow transmitter in field
Differentiate between ultrasonic flowmeter and radar type flow meter
What do you know about gail?
How is work 5/2 sov?
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
any body who gone thru recent iocl interview.INSTRUMENTATION questions. I need.
In turbine what does term CDP, NH, HSSOC means.
Specific gravity.
How to calibrate smoke Dectector
pls provide me syllabus and old question paper of instrumentation engineering for GET(JSPL)
Pressure tx shows 1 mbar but we need 1000 mbar at this process condition .. how can we sort it out .
Can Any body tell me about the Contact or Email id of any good Consultancy which help me to find a job in Instrumentation Field in India .I have Six years of Work Experience in the Same field.Please revert me back on shammi_gwalior@yahoo.com ?
What is the diffrence between ff tx and non ff tx
What is stripper & spilitter ? Diffrence in this.?
What is sensitivity in vibration probes..?
