Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / rajesh
Diversity factor is actually factor considered while
designing the power supply. Though system would be designed
for full load but at any given time generally 60-70% of
loads would work. Hence diversity factor would always be
less than 1.
| Is This Answer Correct ? | 19 Yes | 52 No |
Post New Answer View All Answers
what is earthing.how we make it,describe briefly.
what is a composite error in current transformers, why occurs & in which it will occur i.e, either metering ct/ protection ct
What are the effects of adding a zero to a system?
if grounding is notdone at regular intervals for long distance transmission, will the load connected at distribution end receive voltage during negativehalf cycle of the sine wave?
Why the symbol of register is "zig zag"
why the active power flow of some line is increased when the active power of out is cut ?
How to select HT/MV cable size ?
What will be the impact on motor performance if a LT motor is rewound with changed motor winding data as given below:- Original winding data: total 04 wires = 02 wires of 17 SWG + 02 wires of 16.5 SWG. Changed Winding data: total 03 wires of 15.5 SWG wire size Motor rating: 160KW, 740RPM, 415V, ID FAN application. Normal Running Current = 95% of FL Current.
what happen when increase or decrease size of lamp,light.glass.
ROC converges if poles and zeros lie inside a. Origion b. Z=1
What do you mean by cogeneration? What its working principle?
why the difference arise between HT reading & LT reading (submeters fixed in complexes, apartments etc)if the power factos exceed from 0.9 to 1 can the ht meter reads fast?
What is the effect of solar radiation on the design of an Isolated Phase Busduct?
A 3-phase IM is supplied from 50 Hz system. It runs at speed of 1440 rpm and slip equal to 4 %. Calculate number of pole pairs. A 1 B 6 C 2 D 3
CBCT selection
