How to control speed of DC motor with AC power?
- 7 Answers
- 12152 Views
- vguard, I also Faced
- E-Mail Answers
Answer Posted / saeid
I don't really understand why using field control can be
dangerous for a DC motor while this technique has been used
in thousands of application around the world without any
problem.
Any way, in order to control a DC motor, there are three
general ways: Armature voltage control
Field voltage control
Armature resistance control
| Is This Answer Correct ? | 12 Yes | 5 No |
Post New Answer View All Answers
how we provide neutral earth on synchronising panel as per electrical standards?
11000volt DG set carnt kaise banvay
oltc of a transformer, how it works? and what are the equipment consist of describe briefly?
what is the meaning of the symbol << >> put in transformer drawing
UG cable sizes were specified in sqmm. But practically its not coming to mesure. What's the reason for that? And how they specify the size of the cable?
How is efficiency of DG set calculated? At many places I found the efficiency to be mentioned in percentage. But at some other places I found kWH/ litres. I want to know how dimensionless percentage value is arrived at?
What is the basic principle of operation of alternators/dc generators?
WHY TERTIARY OF POWER TRANSFORMERS IS LOADED WITH EQUIPMENTS LIKE CT,PT,ISOLATOR AND CB
why three phase capacitor takes unbalanced current in capacitor bank?
Why we use mho Relay in long transmission line?
what are safety measures in /control in diesal engine/ explain them?
3 shows a 415 V, 3-phase generator supplying a 3-phase 415/110 V transformer. Draw the individual and combined impedance diagrams to a base of 10 kVA. Determine the system fault kVA and the fault currents at the 415 V and 110 V busbars for short circuit faults on the transformer input or output terminals. Work in p.u. values of impedances.
sir, iam a electrical engg graduate and i want to go in automation sector and for this i have decided to do industrial training for this,plz suggest me some good institute for the same in delhi,ncr. my degree percentage is 58%, can i get job after doing training, plz help....
ASTM D 3455 - Standard Test Methods for Compatibility of Construction Material with Electrical Insulating Oil of Petroleum Origin has been used for Testing Transformer Oils with a product placed in it. Aged Control Oil has a Power Factor of 0.032% at 100°C. Aged Oil with a Test component has a Power Factor of 0.093% at 100°. Is this increase acceptable? If not why? How much increase is acceptable?
if 6 earth pit value is 1.5 ohm then what should be the number of earth pit to make the value .8 ohm
