Answer Posted / satya dev ( knight frank)
Which type of pumop you are asking. There are many types of
pumps using for DG.
PT Pump----- For fuel supply
Coolant Pump- for circulation of water in DG water jacket
priming Pump-- For Circulation of Lube oil
| Is This Answer Correct ? | 23 Yes | 0 No |
Post New Answer View All Answers
if 12v battery get discharged for 2 months after if we put charge it will charge again?how much time it will take to charge?
why don't we use the generator as a motor? and what will happen?
How many lightning arrestors to be installed on 50MX60MX10M building and is there any formular for that?
How can we checked Killo Watts of Motor & Alternator?
When a square wave is applied to primary of a transformer then what will be output wave form of secondary ?
what are the standard IR values should be of R-E, Y-E, B-E, R-Y, Y-B, B-R of VCB in closed condition and in open condition for 500KVA & 1000KVA transformers. and what is the acceptable range when tested by 5000V megger.
why is using sensor?what is differece between photoelectric and proxmitty?
I have doubt that the supply HZ (very low or high than rated ) may affect the power factor. is it true. ?
The D.C. spark test is applicable to single conductor cable & assemblies of insulated single conductor cables without insulation shield,metallic sheath or metalic armor?
explain remenance . differentiate high remenance type ct & low remenance type ct
Why in metering Ct for ammeters ct secondary side is grounded for each Ct but not in case of CBCT (Core balance current transformer)..kindly some1 highlights the reason..is it because net flux is zero?
what percent do you derate your copper wire when you change from copper buss to copper wire
What is the difference between grid and off- grid system??
HOW TO CALCULATE AMPs OF CURRENT TRANSFORMER IN HT Panel
What is load boxes ?