Interested to Buy Any Domain ? << Click Here >> for more details...
How we detect the leakage current of 11 KV H.T. motors and
waht is the maximim limit?
- 3 Answers
- 9576 Views
- Ambuja, Pristine, I also Faced
- E-Mail Answers
Answer Posted / prabhu gnanasekaran
There are two issuse excisting 1.Leakage current2.return
current. Return current is nothing but the it is a small
amout of current that flows in the neutral when the circuit
is not closed. These neutral current can be senced by RCD
(Recidual current devises). Wheareas the leakage current is
one when your cable is shorted or any open circuit to the
ground which can be senced by CORE BLANCE CURRENT
TRANSFORMERS. When there is no leakage current then the
current in all the 3 core will be same. If any leakage
current excits then the current will not be same.
| Is This Answer Correct ? | 11 Yes | 6 No |
Post New Answer View All Answers
Is a d.c.compound motor is use as a booster? how?
can i use the six sigma method which is used in management area, in state estimation of power systems?
how harmonics generated in induction furnance? how minimise it?
wat is the current produced in a 5000v megger? when the positive and negetive terminals are touched on our body get s shock?
how can we select the appropriate VCB ?
The magnitude of sum of two sinusoidal av voltage is equal to 230 volt.the magnitude of each individual voltage is also equal to 230 volt.what must be the phase difference between voltages?
how to electrically make connection to ferroli GN2N?
What is “pu” in electrical engineering?
what is the significance of cabability curve of alternator
An impedance of 100 ohms resistance and an unknown inductance is connected across the capacitor. The resulting impedance is a pure resistance of 500 ohms ifω = 10^5 rad/sec. calculate the values of inductor and capacitor.
What are books to be referred for KPTCL exam?
What is the Basic Difference bitween Long Shunt Connection and Short Shunt Connection in DC Generator?
he compression ratio for a petrol engine generally lies between
PLZ sent the previous year question paper for GET in NHPC on my EMail id ppshanker@gmail.com
I have made a 3 phase thyristor full bridge rectifier. But at the moment it is working only for the half bridge operation. Both the half bridges are on operation separately but when i put it into full bridge operation the oscilloscope output is zero. I rechecked that the pulses are correct for each thyristor. what could be the possible reason for this?
