Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / mani
inches of water column
| Is This Answer Correct ? | 1 Yes | 4 No |
Post New Answer View All Answers
what size steel armoured cable is required to support 1500kva capacity. would 70mm squared be enough or would I need 90 or 120mm squared 3c plus earth
What will happen if the voltage in my house drops from 220V to any lower voltage?
How isolater function when installed inelectrical 440V wiring
why do you add the load short circuit impedance when considering short circuit amperage. It seems that you should only consider supply. If you need to consider loads and you don't know what loads are to be added , what would be a good sub-transient reactance rating for the loads?
Why does the rotor rotate?
How cmd is calculated in case of energy neters
Please define ohm’s law for a.c (alternating current)?
What is the dc grounding system and what is diff between AC/DC grounding system?
What are the advantages of a three-phase system over a single-phase system?
We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?
Why armature rheostat is kept in maximum position?
what is interfacing in computer studies?
Can any one give an explanation about rating factors of cable? if we are laying the cable on the air with an temp 15 degree then rating factors will be 1.15 and if we are laying the cable on the air an temp 60 degree then rating factor will be 0.76 please describe it and what is the difference between rating factor and derating factor?
Which cable is use for rtcc control panel
The size and construction of bushings in a transformer depend upon?
