Why we are using Ohm's law? where it is applicable? explain.
- 10 Answers
- 19024 Views
- Pyramid Saimira, TCS, I also Faced
- E-Mail Answers
Answer Posted / tcs
Ohm's law is used to find the voltage of the system whoose
Current carring capacity and resistance of the system.
| Is This Answer Correct ? | 4 Yes | 6 No |
Post New Answer View All Answers
PLZ SEND ME SOME UNIQUE PROJECT OF ELECTRICAL ENG (B.TECH)
How out of step protection relay works?
what is spadar bar .why I use in DC generator.
What are the criteria shall be considers for sizing Fuse and MCB? If the rated current is 10Amps what should be the fuse size / MCB Size?
What would be the size of wire used for 2 Ton of window A.C?
Dear Sir/Madam, I have one questions we have three steam turbines and one Gas turbine and our industry linked with the public network, we have protection system one of the protection is reverse power we can export just four MW only i would like to ask about how to calculate the reverse power. Thank you in advance best regards
Ceiling Fan and Storage type water heater. Discuss
what is the isolation transformer. what is the isolator?
Different STANDARDS (BS, IS, IEC etc) gives different informations on CT specification. How they correspons w r t each other (i.e I mean to say BS provides "knee point voltage" but IS does not, then how can i select CT)
Name two low frequency oscillators?
What is different bewteen low or high impedance busbar protection scheme
What is given by the definition in BIL IMP/PF = 950/395 kV. This was found in a name plate of a power transformer.
Why is better to have a minimum ceiling voltage of 250% than 160%?
How many types of circuit loads are there in a common electrical circuit?
Please give me a erda placement paper
