what do you mean by 1 ton in AC`s
- 36 Answers
- 108951 Views
- Bhel, Bosch, ITC Infotech, I also Faced
- E-Mail Answers
Answer Posted / venkat iyer
It is the Heat required to melt one ton of ice (2000 lbs)
in 24 hours without increase in its temperature
= 1 x 2000 lbs x 144 btu / pound = 288000 BU or
1200 BTU/hour or 200 BTU / minute
| Is This Answer Correct ? | 36 Yes | 22 No |
Post New Answer View All Answers
How o select the electrical fuse?.What are its characteristics.How to select the material od fuse?
Can you explain about TEE protection scheme?
It is desired to flood light the front of a building 42 meters wide and 16 meters hig.Projectors of 30 degree beam spread and 1000 watt lamps giving 20 lumen/watt are availabl.If the desired level of illumination is 75 lumen/m and show a suitable scheme.Assume the cofficient of utilization, deprecitation factor and waste light factor are 0.4, 13 and 1.2 respectively.
why high speed tripping relay is used in protection circuit why not normal relay
Is there any type of starter for DC motor other than two point,Three point and Four point starters?
What is line resistance of cable & how it can be measured ?
State the frequency for rc phase shift oscillator?
how to test the turn ratio of 3 phase transformer using volt meter shoe the curcit diagram.
What are the applications of autotransformers?
What are the applications of different multistage amplifiers?Plz also write advantages of these amplifiers? Thaaaaaaaaanx
Why can't we parallel the secondary circuits of two voltage transformers?
for opening electrical shop, tips needed.
What is knee point voltage?
my UPS suddenly goes off and all panel light also blow off.This happens even main electric supply is not interrupted.After some time it automatically starts functioning normally.Batteries are new.
sir pls send the je exam - 2008 and other model question papers..
