Answer Posted / sachin vaish
Network testing is carried to check the health status and
address the problems fased by the network such as low
bandwidth , delay ,jitter ,congestion etc.
It is carried on nodes facing issue or noded that are
expected to give better results.
checking the hardware requirments.
policys on the node ,ACLs
misconfiguration , and proper allocation of resources are
common task to be handeled.
checking IDS and IPS are also major task
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
What MAU?
Write down the basic features of HDLC protocol? Could HDLC be used as a data link protocol for a LAN? Justify your answer.
Dear Sir, I have installed 40 HCL thin clients model BVX 4000 on windows 2003 server in the RDP mode, Processor is xeon 3040 1.667 GHZ, with 320 GB SATA Hard Disc and and 1 GB RAM ECC DDR II RAM , in have also expanded the RAM to 8 GB. but still the Graphics and ppt are opening in frames. please do suggest me how can i use these thin Clients to work in the normal pc mode so that the graphics( Photos .JPEG images and normal power point presentations.? Regards ather.
Explain leaky bucket algorithm and compare it with token bucket algorithm.
What is the range of addresses in the classes of internet addresses
Differentiate between IEEE 802.3, IEEE 802.4 and IEEE 802.5 standards.
What are the two reasons for using layered protocols?
What are the networking protocol options for the Windows clients if for some reason you do not want to use TCP or IP?
Why does ATM use the cell of small and fixed length ?
Explain network layer in ATM,
Explain any three error detection and correction techniques.
What is Mail Gateway
A binary signal is sent over a 3-khz channel whose signal-to-noise ratio is 20 db.Calculate the maximum achievable data rate ?
Why is IP called ‘best-effort delivery’ protocol?
What are the other names of IEEE 802.11 protocol or standard?
