Answer Posted / kalirajan.n

Gas blast applied on the arc must be able to cool it rapidly
so that gas temperature between the contacts is reduced from
20,000 K to less than 2000 K in a few hundred microseconds,
so that it is able to withstand the transient recovery
voltage that is applied across the contacts after current
interruption. Sulphur hexafluoride is generally used in
present high-voltage circuit-breakers (of rated voltage
higher than 52 kV).

In the 1980s and 1990s, the pressure necessary to blast the
arc was generated mostly by gas heating using arc energy. It
is now possible to use low energy spring-loaded mechanisms
to drive high-voltage circuit-breakers up to 800 kV

what is meaning of 230volts ac 50hzs ac supply is it rms or maximum to getting ac 230v what amount of max voltage they will send

2003

---

what is 30-phase of transformer

2235

---

Witch do depand of Power factor and theory of power factor?

2035

---

block diagram of 2 ups system connected in parallel mode?

2034

---

How CFL &T5 tube light glows?

1974

---

which model T or pie model is prefarable in power syatem

1823

---

What should be the height of basement according to NBCC code?

2143

---

what is the difference between Central Battery System and UPS in applications and uses? and why UPS suitable for Computers and central battery for emergency lighting?

10210

---

What is the principle of HIGH SPEED DIRECT DRIVE MOTOR ?

1944

---

will there be any problem by recovering slip from single phase induction motors?

1823

---

How earthing of switchgear system to be done.

1878

---

battery capacity use of made?

2480

---

how to select correct size of power cable for inverter duty motor

1502

---

Write a note on materials used as a fuse element.

2067

---

Why and when NGR panel required. Is it necessary to design a NGR panel for a 6.6kV Alternator paralleling with Grid????

2698

---