Interested to Buy Any Domain ? << Click Here >> for more details...
WHAT HAPPEN WHEN CT SECONDARY OPEN DURING LOAD
- 16 Answers
- 31810 Views
- Neco, I also Faced
- E-Mail Answers
Answer Posted / v.selvakumar
if ct opens during heavy load , heavy voltage will appear
across ct secondary ,because of no oppossing emf present
primary.result ct will blast
| Is This Answer Correct ? | 3 Yes | 8 No |
Post New Answer View All Answers
which type of motor is used in automatic swing gate
What are diffrent type of road taxes?
I have one ct of ratio 3000-2000/1 Amp its knee point voltage mentioned on name plate is 500-333/30mA-50mA at Vk/2. in secondary box there is three terminal named 1S1, 1S2, 1S3 then on which terminal obtained the knee point voltage ie 1S1-1S2 OR 1S1-1S3 & also specify the knee point voltage for the ratio 3000 from name plate.
what kind of technical test that i need to learn because i have an interview tomorrow.. please someone help me..
We have Diesel generator of 200KW. fuel consumption is always same,even connected light load or full load. Is it right?
In parallel operation time both NGR’s close or not close if both close what will happen
for 750 kw LT load what will be the ht kva
What is effect on in zone and out zone fault if CT chosen for phase side is Vk/2<5mA and Neutral side is Vk/2<15mA on REF protection of Transformer
Briefly describe means used by electricity suppliers to influence the flow of active and reactive power in power networks (one for each type)?
in a simple IDMT relay we use neutral point of ct for earth fault then what is the requirement of neutral ct and cbct?
why US countries maintains 110v and 60HZ
where can i get vijaya electricals limited in hyderabad interview auestions can u give me the website address plz
for 5KW resistive load can anyone please suggest me whether to go for UPS/Inverter or Generator depending upon cost calulations
What is the percentage loss for aluminium wire for HT line more than 11KVa
is it possible to have dc motors on single chip
