Interested to Buy Any Domain ? << Click Here >> for more details...
Respected Sir,
Please send me the technical question paper of
ONGC of mechanical branch.I m in urgent need of it.
- 7 Answers
- 11492 Views
- NTPC, ONGC, I also Faced
- E-Mail Answers
Answer Posted / raj
yaar, i am also searching the same??????
| Is This Answer Correct ? | 6 Yes | 6 No |
Post New Answer View All Answers
bel question
How would you increase the volume efficiency of centrifugal pump?
why we use kg/cm2 in pressure gauge not kg/m2
What is the temperature at which diesel normally boils?
2. Dry saturated steam at 3.5 bar is expanded through a convergent nozzle to 2.2 bar. The exit area is 5 sq. cm. Calculate the exit velocity and mass flow rate, assuming isentropic expansion and super saturated flow. b) A cast iron cylinder head is fastened to a cylinder of 750mm bore with 12 stud bolts. The maximum pressure inside the cylinder is 3 Mpa. The stiffness of part is thrice the stiffness of the bolt. What should be the initial tightening load so that the point is leak proof at maximum pressure? Also choose a suitable bolt for the above application 2 The propeller shaft of a marine engine is to transmit 600 kW at 1200 rpm, without a significant bending. The efficiency of the propeller is 88% at 32 knots ( 1 knot = 1085 km/hr). If the slenderness ratio is less than 50 and the permissible shear stress should not exceed 65 Mpa. Determine the diameter of shaft. 3 A semi-elliptic leaf spring consists of two extra full-length leaves and six graduated length leaves, including the master leaf. Each leaf is 7.2 mm thick and 65 mm wide. The centre-to-centre distance between the two eyes is 1.3m. The leaves are pre-stressed in such a way that when the load is maximum, stress induced in all leaves are equal to 380 N/mm sq. Determine the maximum force that the spring can withstand
State newton's three laws of motion.
What pressure is highest L.O. Gravity Head or S.W. of the stern tube circulation
Define enthalpy?
What is the use for firmer chisel?
Explain the types of elasticity?
how to select a pump (in hp) for lifting water from a Borewell upto a height of 320feet? Is there any thumb rule?
i require technical question paper which has been asked in last railway recruitment board exam for the post of junior engr.
How does hydraulics work?
What are the advantages of a centrifugal pump over a reciprocating pump?
On what basis can sliding contact bearings be classified? Explain?
