Answer Posted / priyanka baranwal
to measure the diameter of any job between jaws of micromeer
is fixed by rotating the ratchet.
Is This Answer Correct ? | 0 Yes | 5 No |
Post New Answer View All Answers
CAN SOMEONE GIVE ME THE LINE DIAGRAM OF A VAPOUR ABSORPTION SYSTEM (VAM)(AIRCONDITIONING)AND A 600 TON CENTRICUGAL AIRCONDITIONING PLANT.
From where compressor recive power in automobile?
What is the purpose of increasing the pressure on the F.O. system of the engine?
If gas turbine is operating on part load, how droop will affect the output with respect to frequency.
"How to check the diode, fuse and bearer switch?"
for under water excavation works, can i have some standard codes and specifications(international)
What are your specific job requirements in mechanical engineers?
what is cyclon seperator and water column?
What is the purpose of air cooler of D/E?
How to calibrate Vacuum Gauges if you don't have any standard gauge available with you? please suggest procedures for calibration of Vacuum gauge like pirani gauge ,cold cathod gauge,thermocouple gauge without any standard gauge.
How do you control cylinder liner wear?
pls send the technical question paper
Why tampering to be done?
What are sleeve and cotter joint?
diffuser increases pressure but in turbine pressure is decreasing when steam passing through casing?