Interested to Buy Any Domain ? << Click Here >> for more details...
can aluminium be welded?if so say the type used for it?
- 4 Answers
- 7089 Views
- I also Faced
- E-Mail Answers
Answer Posted / bajadave
Yes, Tig welding
| Is This Answer Correct ? | 5 Yes | 1 No |
Post New Answer View All Answers
In process control loop e/p converter receives 4-20 ma input current from which control block?
Interview question paper
AFTER OVERHAULING KTA19G3 AND JUST ABOUT TO START ,BUT WE DIDNT FIX THE OIL SUMP AND TEST FOR -WATER LEAK FROM LINER O RING SIDE,THEN WE FILLED WATER AND FOUND WATER LEAK FROM INSIDE OF ENGINE -CAM FOLLOWER SIDE PLEASE GIVE ADVICE TO RECTIFY THE SAME
plz send me paper of mppgcl 2008 or experience posted by any candidate
Is it the relation between friction and power losses ? is it relation among stress, friction and power loses in cicular ring ?
What is a turboprop engine?
Inspection for intermediate shaft bearing.
How many battery discharges?
Distinguish between creep and fatigue.
Where do railway steam engines carry there water?
What pressure is highest L.O. Gravity Head or S.W. of the stern tube circulation
differentiate between total moisture and inherent moisture of coal.
What is the importance of Prandtl Number in heat transfer?.
Define radiation.
2. Dry saturated steam at 3.5 bar is expanded through a convergent nozzle to 2.2 bar. The exit area is 5 sq. cm. Calculate the exit velocity and mass flow rate, assuming isentropic expansion and super saturated flow. b) A cast iron cylinder head is fastened to a cylinder of 750mm bore with 12 stud bolts. The maximum pressure inside the cylinder is 3 Mpa. The stiffness of part is thrice the stiffness of the bolt. What should be the initial tightening load so that the point is leak proof at maximum pressure? Also choose a suitable bolt for the above application 2 The propeller shaft of a marine engine is to transmit 600 kW at 1200 rpm, without a significant bending. The efficiency of the propeller is 88% at 32 knots ( 1 knot = 1085 km/hr). If the slenderness ratio is less than 50 and the permissible shear stress should not exceed 65 Mpa. Determine the diameter of shaft. 3 A semi-elliptic leaf spring consists of two extra full-length leaves and six graduated length leaves, including the master leaf. Each leaf is 7.2 mm thick and 65 mm wide. The centre-to-centre distance between the two eyes is 1.3m. The leaves are pre-stressed in such a way that when the load is maximum, stress induced in all leaves are equal to 380 N/mm sq. Determine the maximum force that the spring can withstand
