Interested to Buy Any Domain ? << Click Here >> for more details...
How to increse bearing capacity in soils (Stabilisation of
soils)
- 12 Answers
- 21850 Views
- I also Faced
- E-Mail Answers
Answer Posted / somaning r pujari
By spreading soil n sprinkling water n rolling over it
layer by layer.
| Is This Answer Correct ? | 14 Yes | 2 No |
Post New Answer View All Answers
qty. of cement & sand required (100sq.mtr) for fixing of floor and wall tiles also fixing of marble stone on the floor
In foundation design, while we do the base pressure check, we normally check if the attained pressure value is less than the GROSS BEARING CAPACITY of the soil which is the sum of net bearing capacity of soil and the overburden pressure. Actually, the overburden pressure acts against the net bearing capacity of the soil and I feel that we are actually increasing the bearing capacity value and doing the check. I feel that this is NOT right. Please clarify on this.
With reference to construction of state highways, please let me know the total Bill Of Quantities as per the following details:- 1) Subgrade - 500 mm 2) Granular Sub-Base (GSB) - 200 mm 3) Wet Mix Macadam I (WMM I) - 150 mm 4) Wet Mix Macadam II (WMM II) - 100 mm 5) Dense Bituminous Macadam (DBM) - 60 mm 6) Bituminous Crust (BC) - 40 mm Road Length is 44 Kms. Road Width is 7 mtrs. Please provide the BOQ of each layer as per Compacted Factor & Loose Factor both. Also, if possible please provide me the approximate details of total material required (all categories viz. soil, gravel, stone aggregrate, sand, bitumen etc.) as per general mix design prevailing in India. Thanks & Regards -- Rokr
a solid steel rod length 2m dia and 20mm vertically hangs from celling and has a collar firmly atteched to it. above the collar an annular rubber washer of 40mm th. having stifness k = 5n/mm is placed. determine maximum stress in the rod caused by mass of 5 kg falling through a height of 1.2m.
What are some structures that may be subjected to fatigue?
Explain how you can use different dimension tools in CAD? What are the different dimensions available?
Aptitude, reasoning, quants, verbal and technical question
Can inverted beams used in pipes during construction?
What is the sugested procedure of water purification for public supply?
rimmer in pile foundation
How many % we consider for lap for reinforcement for estimates
why should we use 20mm graded metal only in vrcc?why we shouldnot use 40mm metal?
what is the permanent solution applied for restoration of leaning tower of pisa?
How much Tolerance factors like 1. brick work 2.plaster 3.painting 4.floor tiling 5.wall tiling 6.shuttering 7.concreting 8.steel
why the cracks occurs in NP3 class Hume Pipe ? And what is bearing capacity of it?
