Interested to Buy Any Domain ? << Click Here >> for more details...
Why Transistors are not used as switching devices?
- 15 Answers
- 31096 Views
- I also Faced
- E-Mail Answers
Answer Posted / sathish.n tessolve
Hi Friends
The reason why we are not using the transistor as
switching device because there is a chance of current flow
from VCC to ground when the transistor is ON.So the
transistor take more power.But this is never happen in the
CMOS device because only one transistor is get ON at a time.
| Is This Answer Correct ? | 1 Yes | 5 No |
Post New Answer View All Answers
why do we use 25kv supply for traction purpose?
how does grading rings & spacers in transmission line works? Working Principle?
What is the resonant peak?
How do we calculate transformer oil in liter from the rating of the transformer.
UG cable sizes were specified in sqmm. But practically its not coming to mesure. What's the reason for that? And how they specify the size of the cable?
what is the difference between general inverter and solor inverter clerly explain plz
2. What are the parameters of EHT sub-station?
what exactly commisioning work does in electrical site work... LT side?..
how i chosse capacitor bank if my energy meter is 48 kvr? tell me capacitor bank chossen formula?
What is meant by bus bar protection?
at work we have a 3 phase motor but on testing one phase isnt getting a reading. it runs 24 hours a day all week. stops and starts well no noise or heating. the phase isnt down to earth.is it just a bad meter reading or not? phases one and three came up with a resistance reading of 0.4 but phase 2 couldnt get anything shows up as open circuit.
We have 5 Distribution sections with variable loads&We have 3 Gensets(500kva,380kva&250kva) our total load is between 400kva to 600kva. so how could we connect 3gensets.
Differentiate between kirchhoff’s first law and kirchhoff’s second law?
Safety of dry type transformer
static chagre
