How one can check the faulty capacitor, diode when
connected in the circuit ? and when you can not take them
out ?
Answer Posted / pyobik
The circuit can be checked by testing its continuity! from
both the sides of the terminals.
As because the faulty capacitor will be shorted and the
diode junction would have been breakdown!
Is This Answer Correct ? | 10 Yes | 7 No |
Post New Answer View All Answers
why sielent pole is used only in hydro generators and not in turbo generators
Why compensation is necessary in feedback control system?
A powerplant has 8 gensets operating in grid parallel mode. In one genset sometimes there is pf variation and kvar variation. The plant operates in pf mode. When this variation is observed the load is stable, voltage is also stable, freq and genset speed is also stable. How will you check the functioning of pf card. What shall be the ideal output vdc of the pfc, from there it is input to AVR?
hi this is hema can anyone mail me previous years questions for the APPSC-A.E.E (in electrical stream.) ......thank u.
What are the different types of hydro schemes?
how to determine the inrush current of a transformer
Define step response?
Good day everyone,currently in our premise we using 30kw slip ring motor with resistance bank which we use as forward and reverse at conveyor bar handling. So,my question is how do we calculate the resistance bank which is suit the motor. Kindly,assist me... thank you
does any one know where we can purchase insulation oil for high voltage oil filled cables
When steam condenses and becomes water at the same temperature, the specific heat for the process in kJ/kg k is
what is the acceptable value of TAN DELTA and dissipation factor for 11kV, 1.75HP Motor?.
hi, could someone help me to find a control design for syncronising panel .
State the types of distortions in amplifier?
i am an maintenance engineer. one distribution board have 5 feeder. recently its ELR trips frequently, but it take some times after trip( 10min,20min..)but 3 feeder no load. two feeder only loaded. i checked one feeder IR value all values are above 50Mohm.but B phase to Earth is only 9Mohm.any problem about low value
which protection function should measure RMS value of current&DFT value of current?