Interested to Buy Any Domain ? << Click Here >> for more details...
What is the difference between CRNO and CRGO in an
transformer and what is the advantages of these two.
- 13 Answers
- 73759 Views
- Anchor, CIL, ETA, Kirloskar, I also Faced
- E-Mail Answers
Answer Posted / vinothbabu.k
I DONT KNOW ABT THE CRNO,BUT I KNOW ABT THE CRGO-IS COLD
ROLED GRAIN ORIENTD,ITS THE MATERIAL USED IN THE
TRANSFORMER WINDING....
| Is This Answer Correct ? | 68 Yes | 52 No |
Post New Answer View All Answers
I have a situation to design sub-Distribution board/Panel meant for feeding power sockets. In the incomer CAN i Take TP MCCB with Neutral Link and All the outgoing feeders with to sockets with TP MCCB and Neutral Link? P.S : My System is IT Earthing
why current flow to the opposite direction of flow of electrons???????????
why is using sensor?what is differece between photoelectric and proxmitty?
In radial network the source is fed from 1 end both ends at central
I want d.g.set our company
For RCD (Residual current device) Icu is defined. How i can find Ics for them?
what are the accessories need to be added while doing estimation for the following: 1.MCCB 2.MCB 3.ACB
What will be the impact on motor performance if a LT motor is rewound with changed motor winding data as given below:- Original winding data: total 04 wires = 02 wires of 17 SWG + 02 wires of 16.5 SWG. Changed Winding data: total 03 wires of 15.5 SWG wire size Motor rating: 160KW, 740RPM, 415V, ID FAN application. Normal Running Current = 95% of FL Current.
TCS IS IT COMPANY THEN WHY DO THEY NEED ELECTRICAL &ELECTRONICS ENGINEERS?
in what type of applications v can use q meter?
how to calculate the battery AH
What are high pass filter and low pass filter? and What are the flowmeter ?
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
Single line diagram for dbb (double bus bar)system.
Can you used moeller lzm1 mccb in a dc system with 125vdc and 20ka short circuit current , beside is it have 24 or 48 volt shunt ? Beside how long current can through from An MCB shunt contacts? (like Z7-AS 24 V)?
