Interested to Buy Any Domain ? << Click Here >> for more details...
- Civil Engineering (1773)
- Mechanical Engineering (2114)
- Electrical Engineering (5448)
- Electronics Communications (2383)
- Chemical Engineering (515)
- Aeronautical Engineering (176)
- Bio Engineering (77)
- Metallurgy (300)
- Industrial Engineering (171)
- Instrumentation (934)
- Automobile Engineering (238)
- Mechatronics Engineering (65)
- Marine Engineering (82)
- Power Plant Engineering (36)
- Textile Engineering (575)
- Production Engineering (25)
- Satellite Systems Engineering (102)
- Engineering AllOther (932)
why top layer of block work shoud be full size if any cut block adjustable than another layer?
how to calculate the rebar depth if forgot the foundation reinforcement (main steel)? is that any calculation or formula we have data sheet of supplier what depth what is the pull out capacity is mensioned in data sheet. if any IS code than its help full to me.
what is milling and types of milling?what is drilling and types of drilling? what is tapering and their types?
in non technical way how can u define POWER FACTOR??
what is the control circuit for operating the clean room air shower
11KV AND 22KV NETWORK KW CAPACITY IN RING AND RADIAL?
design a LV scheme for a 15 storied building?
How to work E.L.C.B and how to connect in circuit.
How many kinds of E.L.C.B and how to work E.L.C.B
Minimum IR value of 1.1 kv grade 3.5c (300, 240,185,150,120,95,70,50,35,25) sqmm Aluminium XLPE cable and 4c (16, 10,6 & 4) sqmm cu arm cable between RY,YB,BR,RN,YN,BN,RE,YE,BE & NE.
what is magnetizing and demagnetizing current in generator and motor?
Swg formulae
why ten delta testing is carried out on power transformer
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
what is the safe meggar values for motor, transformer HT, LT and Cables? IF we want to replace I/C bay at our 220 kv substation which is of 140 mw load capacity bay to be replaced by 400 mw capacity bay.other than CT(1200/1) what are the other equipment i have to replace. why we generally use 3.5 core cable or in other word 1/2 core for neutral and also confirm me that in balance conditiob(3 phase)current in neutral will zero
