On what basis the the size of Lightning arrester for buildings are selected ?

KGD,

Motor,transformers,capacitor tubelight etc....

why Lightening Arrester Probe sharp at Top of telecom tower.

Reliance Jio,

Question 58 – In the design of a solar power system steps of calculations below are followed : (a) The power output of the inverter of the of the solar panel is 100 watts. What is the power input, Pin to the inverter when the efficiency of the inverter is 50 %? (b) If the rated power of the inverter is 300 watts, how many inverter is needed for the solar panel? (c) Charge controller of V = 12 volts is used to supply power to the inverter. What is the input current I to the inverter? (d) If the charge controller capacity is 10 A, how many charge controllers are needed? (e) If a biochemical mixer consumes 100 watts, running for 2 hours per day, what is the energy consumption in kilowatt hour per day? (f) What is the input energy needed when the efficiency of the inverter is 50 %? (g) If your area receives 2.88 hours of full sunlight per day, how much energy, in kilowatt hour can be produced per day when one solar panel can produce 20 watts of power? (h) If you know that you have to produce total energy as the answer for (f), how many solar panels are needed? (i) Each V = 12 V battery has 5 ampere hours. If the total energy needed is in answer (f), then how many batteries are needed to run the biochemical mixer if without sunlight for 3 days?

When doing a liquid seal on a differential flow transmitter , most of the time the sealing liquid will be heavier then the process fluid. For wich application will the sealing liquid be lighter than the process fluid if transmitter is mounted below the process line.

Chevron,

how to Select Lighting arrester? What r the parameters to be considered for the selection of Lighting arrester ?

What is the possible cause for failure of lightning arrestors in outdoor substation under normal condition

Question 61 – A biochemical trolley of mass 15 kg is towing a trailer of mass 5 kg along a straight horizontal pathway. The trailer and the trolley are connected by a light inextensible tow-bar. The engine of the trolley exerts a driving force of magnitude 100 N. The trailer and the trolley experience resistances of magnitude 10 N and 30 N respectively. (a) Form 2 equations with unknowns T and a, that represents the equilibrium for the 2 systems of the trolley and trailer. (b) Solve the simultaneous equations from the 2 equations that are obtained in part (a) of this question. T is the tension of the tow-bar and a is the acceleration.

In IR spectra, generally a molecule vibrates without apply emr or ir light?

How much tax shall be Levi on products like Tube light, bulb, electric fixtures in Karnataka state?

List out the the types of Mounting Light fixture?

HLL,

Question 79 - (a) The American Petroleum Institute gravity, or API gravity, is a measure of how heavy or light a petroleum liquid is compared to water. Let SG = specific gravity of petroleum liquid, and V = barrels of crude oil per metric ton. Given the formula for API gravity = 141.5 / SG - 131.5 and V = (API gravity + 131.5) / (141.5 x 0.159), find the relationship of SG as a function of V. (b) An oil barrel is about 159 litres. If a cylinder with diameter d = 50 cm and height h = 50 cm is used to contain the oil, find the volume V of the cylinder in the unit of oil barrel by using the formula V = 3.142 x d x h x d / 4. (c) First reference : 1 cubic metre = 6.2898 oil barrels. Second reference : 1 cubic metre = 6.37 oil barrels. What are the 2 factors that cause the difference in such reference data?

Raja was studying for his examinations and the lights went off. It was around 1:00 AM. He lighted two uniform candles of equal length but one thicker than the other. The thick candle is supposed to last six hours and the thin one two hours less. When he finally went to sleep, the thick candle was twice as long as the thin one. For how long did Raja study in candle light?

Zoho,

Question 90 - In the calculation of the growth of bacteria, absorbance, A in spectrophotometry is used. According to Beer-Lambert Law, A = e x l x c where A is the absorbance of the solution (no unit), l is the distance of light travels through the solution (in cm), e is the molar absorptivity or the molar extinction coefficient [ in L / (mol.cm) ]. For a particular solute and fixed path length : As / Ao = Cs / Co where Ao is the observed signal for a known concentration Co, and As is the observed signal for a sample concentration Cs. (a) For a cell concentration of 560 cells / mL, a spectrophotometre gives an absorbance reading of 1.0. A mixture of concentration 3600000 cells / mL can be diluted in several operations, with each operation having a dilution of 1:20. How many dilutions should be made so that the concentration of this mixture can be calculated within a range of A = 0.0 to 1.0. (b) In another experiment, a sample tube of 1 cm in width is used. Let A = 0.06 and e = 0.0012 ml / (cell.cm). Find the cell concentration of the sample.

Question 91 - In the application of Theory of Spectrometry in spectrophotometer, let n = N x C x V, V = A x t, e = a x N where n = number of molecules, N = Avogadro's number, V = volume of cuvette, A = area of cuvette, t = thickness of cuvette, C = concentration of fluid in the cuvette, e = extinction coefficient, a = effective area of molecule. (a) By using calculus in dI = -I x a x N x C x dt, prove that ln (I / Io) = -a x N x C x t, where dI is the small difference in I and dt is the small difference in t. I = intensity of light. Io = initial intensity of light. (b) Show by calculations that ln (Io / I) = e x C x t based on the answer in the previous question (a). (c) Find the equation of log (Io / I) as a function of e, C and t based on the answer in the previous question (b).