Write a pascal program to calculate the sum of the first 100 even number and odd number

write a programe to accept any two number and check the following condition using goto state ment.if a>b,print a & find whether it is even or odd and then print.and a 2016

I have SQLRPGLE program in which there are some update statements which executed correctly. there were no errors run time. Once the program gets over, the file was not updated with the new values. What might be the reason?

Write a program that takes a 5 digit number and calculates 2 power that number and prints it.

Mind Tree,

Write a C Program That Will Count The Number Of Even And Odd Integers In A Set using while loop

HP,

Write a C program to enter 10 integer numbers through one variable and count how many of them are even using while loop ?

write a program using 2 D that searches a number and display the number of items 12 inputs values input 15,20, 13, 30, 38, 40,16, 18, 20 ,18 ,20 enter no. to search : 20

I have string like hp company.print tis like company hp.write a program in vbscripting

HP,

How to make a c++ program that converts any base to base 10?

Write a simple encryption program using string function which apply the substitution method.

program A and B are analysed and found to have worst case running time greater than 150NlogN and N*N respectively. which program has the better guarantee after the running time for the large values of N(N>10000)? which program has the better guarantee for the running time of small program N (N<100)? which program will run faster on average for N=1000?

St. Pauls University,

For each of the following program segments,give a big zero analysis for the running time 1.For (i=0;i

St. Pauls University,

write a c program to calculate sum of digits till it reduces to a single digit using recursion

IBM,

Write a program to encrypt the data in a way that inputs a four digit number and replace each digit by (the sum of that digit plus 7) modulus 10. Then sweep the first digit with the third, second digit with the fourth and print the encrypted number.

CIIT Wah,

A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.

MNC,