Answer / nikhil maggu

I guess RAS

What is the name of distance vector algorithm?

0 Answers  

---

You are a system administrator on a NetWare network, you are running NetWare 4.11 and you cannot communicate with your router. What is the likely problem? A. NetWare 4.11 defaults to 802.2 encapsulation. B. NetWare 4.11 defaults to 802.3 encapsulation C. Cisco routers only work with NetWare 3.11. D. NetWare 3.11 defaults to 802.2 encapsulation.

1 Answers  

---

Tell me how many fillers we can put in one ip of ipv6?

0 Answers  

---

which is following route will be used to froword data in a situation where a routing table tables contains static ,RIP,IGRP routes destined to the same network with each set to its default administrative distance

9 Answers   HCL,

---

what is stp.

4 Answers   IBM,

---

When a router knows the IP address, but does not know the MAC address of the device it wishes to contact, it uses the ARP (Address resolution protocol) to determine the MAC address. After it learns the MAC address, it stores this information in the ARP cache. What is the command to view the ARP cache? A.) sh mac B.) show cache C.) show arp D.) sh arp interfaces E.) show ip cache

2 Answers  

---

Which router command allows you to determine if an IP access list is enabled on a particular interface? A. Router# show ip interface B. Router> show access-list C. Router# show ip access-list D. Router> show interface ip access-list E. Route 1 P.O. box 198

2 Answers  

---

Explain the benefits of VLANs.

0 Answers  

---

Which two statements about a bridge are true? (Choose two) A. A bridge floods multicasts B. A bridge floods broadcasts C. A bridge does not flood multicasts D. A bridge does not flood broadcasts

1 Answers  

---

Mention what is bootp?

0 Answers  

---

What does the parameter -- LOG -- do on an IPX access list? A.) The log keyword is not a valid option. B.) Read the LOG to figure out what traffic to deny. C.) Logs the creation of the access list. D.) Logs IPX access control list violations whenever a packet matches a particular access list entry. E.) Ensures the IPX protocol places a log in the fireplace.

1 Answers  

---

In order to configure a Frame Relay subinterface with IP identify the 2 commands that must be configured on the physcial interface? A.) Router(config-if)# encapsulation frame-relay B.) Router(config-if)# no ip address C.) Router(config-if)#encapsulation subinterface frame-relay D.) Router(config)# subinterface s0 encapsulation frame-relay

2 Answers  

---