Answer / sudeep

it's a
Router(config)#no ip domain lookup

Answer / jitendera kuar sinha

router(config)#no doman look up
i might be wrong but i think i am 75%sure

Answer / khalid

Router(config)#no ip domain-lookup

Answer / gunanidhi sahoo

#no ip domain lookup

Which command would show all Ethernet interfaces with IPX configured on them? A.) show interface ipx ethernet B.) show ipx interface C.) show ipx interface ethernet D.) show ipx E.) show version F.) show run

1 Answers  

---

Which statement about the Point to Point Protocol (PPP) is true? A. PPP supports TCP/IP but not Novell IPX B. PPP is being phased out of existence by the Serial Line Internet Protocol (SLIP) C. PPP providces router to router and host to network connections over both synchronous and asynchronous circuits D. PPP is an ITU T and ANSI standard that defines the process for sending data over a packet switched data network (PSDN)

2 Answers  

---

Which OSI layer defines end to end communication, segmentation and re-assembly? A.) Network B.) Transport C.) Physical D.) Application E.) Data-Link F.) Presentation

1 Answers  

---

What is the default size of frame?

0 Answers  

---

What is the difference between static and dynamic ip addressing?

0 Answers  

---

How does the cut-through switching technique work? A.) By using broadcast address as source addresses B.) The switch waits only for the header to be received before it checks the destination address and starts forwarding the packets C.) The LAN switch copies the entire frame into its onboard buffers and then looks up the destination address in its forwarding, or switching, table and determines the outgoing interface D.) By using a Class I repeater in a collision domain

3 Answers  

---

Which of the following are examples of ICMP? A.) Traceroute B.) Web Browsing C.) Ping D.) Telnet E.) Destination Unreachable message from a router F.) Inverse Tunnels

1 Answers  

---

Identify the prompt displayed if in privileged exec mode? A.) Router(config)# B.) Router# C.) Router> D.) Router(priv)#

2 Answers  

---

Which of the following will show an extended access list 150? A.) sh access-list 150 B.) sh ip int C.) sh ip access-list D.) sh access-list 150 extended

2 Answers  

---

What are hold-downs used for? A.) To prevent regular update messages from reinstating a route that has come back up B.) Information received on an interface cannot be sent back out the same interface C.) To prevent regular update messages from reinstating a route that has gone down D.) To hold the routing table from being sent to another router

1 Answers  

---

If a router uses static routing, how does it learn the route to remote networks? The router uses a RIP request to obtain remote network numbers. The router uses a routing protocol to exchange remote network numbers. The router uses DNS request packets to obtain remote network numbers. The Network Administrator manually configures the remote networks.

1 Answers  

---

What is the default CDP broadcast update rate for Cisco routers? A.) 120 seconds B.) 60 seconds C.) 30 seconds D.) 90 seconds

3 Answers  

---