Explain protocol?
No Answer is Posted For this Question
Be the First to Post Answer
Identify 3 methods used to prevent routing loops? A.) Split horizon B.) Holddown timers C.) Poison reverse D.) SPF algorithm E.) LSP's
In the setup dialog, what do the square brackets indicate? A. current or default spores B. hard coded values that cannot be modified C. values entered by the administrator but not saved D. values that must be written to PAVRAM before becoming enabled
What are the types of communication in ipv6 ?
Regarding frame relay, which of the following statements are true? A.) You must use ANSI encapsulation if connecting to non-Cisco equipment B.) You must use IETF encapsulation if connecing to non-Cisco equipment C.) You must use Q.933a encapsulation if connecing to non-Cisco equipment D.) You must use Cisco encapsulation if connecting to non-Cisco equipment
Which of the following is a characteristic of a switch, but not of a repeater? A.) Switches forward packets based on the IPX or IP address in the frame B.) Switches forward packets based on the IP address in the frame C.) Switches forward packets based on the MAC address in the frame D.) Switches forward packets based only on the IP address in the packet
What is the subnet? Why is it used?
The ICMP (referred to in PFC 1700) is implemented by all TCP/IP hosts A. true B. false
What is the difference between OSPF Exteral Type 1 (O E1) & External Type 2 (O E2) routes????
what is router?
If i had 400 computers set in a site how many VLAN i should configure so that i can share a proper bandwith,and also i had two lease line connection of 2Mbps each,
What is difference between routing and routed protocols?
Which router command allows you to determine if an IP access list is enabled on a particular interface? A. Router# show ip interface B. Router> show access-list C. Router# show ip access-list D. Router> show interface ip access-list E. Route 1 P.O. box 198