As the system administrator, you enter the following commands at the command prompt: ipx routing access-list 800 permit 2b 4d int e0 ipx network 4d ipx access-group 800 out int e1 ipx network 2b int e2 ipx network 3c What did these command accomplish? A. Traffic from network 4c destined for network 4d will be forwarded out Ethernet0. B. Traffic from network 3c destined for network 4d will be forwarded out Ethernet0. C. Traffic from network 2b destined for network 4d will be forwarded out Ethernet0. D. Traffic from network 4d destined for network 2d will be forwarded out Ethernet0.

1 Answers  

---

You are logged into a router, what command would show you the IP addresses of routers connected to you? A. show cdp neighbors detail B. show run C. show neighbors D. show cdp

2 Answers  

---

Novell IPX network addresses have two conferrable parts. The network administrator specifies the IPX network number. How is the node number determined? A. It is the serial number of the given device B. It is assigned as a lease by Novell DHCP C. It is also set by the network administrator D. It is usually the MAC address of one Interface E. It is downloaded by Netware Core Protocol (NCP)

1 Answers  

---

Tell us the name of best path in eigrp protocol?

0 Answers  

---

You have two Cisco routers setup back-to-back in a lab using DTE/DCE cables. To which router would you add the clockrate command? A.) The serial port on the DCE router B.) The Ethernet port on the DTE router C.) The Ethernet port on the DCE router D.) The serial port on the DTE router

3 Answers   TCS,

---

Which frame has a Type field to identify the upper-layer protocol? A.) 802.3 B.) 802.2 C.) 802.5 D.) Ethernet_II

2 Answers  

---

What is poe (power over ethernet)?

0 Answers  

---

You are given the following address: 153.50.6.27/25. Determine the subnet mask, address class, subnet address, and broadcast address. A. 255.255.255.128, B,153.50.6.0, 153.50.6.127 B. 255.255.255.128, C,153.50.6.0, 153.50.6.127 C. 255.255.255.128, C,153.50.6.127, 153.50.6.0 D. 255.255.255.224, C,153.50.6.0, 153.50.6.127

2 Answers  

---

Which device listed below provides clocking for the line? A.) DCE B.) CPE C.) CO D.) DTE E.) Demarc

2 Answers  

---

Identify the correct pair of Novell Ethernet encapsulation and Cisco terminology? A.) Ethernet II, Snap B.) Ethernet 802.3, Novell-Ether C.) Ethernet SNAP, Arpa D.) Ethernet 802.2, Snap

1 Answers  

---

Which statement is true when a broadcast is sent in an Ethernet/802.3 ITAN? A. The ip shored used is 255.255.255.0 B. The IP address used is 255.255.255.255 C. The MAC address used is 00 00 00 00 00 00 D. The MAC address used is FF FF FF FF FF FF

1 Answers  

---

Identify the 2 commands that copies the configuration in NVRAM to RAM? A.) copy backup-config running-config B.) configure nvram C.) copy startup-config running-config D.) configure memory

3 Answers  

---