Which layer is responsible for flow control,
acknowledgement, and
windowing?
A.) Transport
B.) Network
C.) Application
D.) Session
E.) Physical
F.) Data Link
- 2 Answers
- 5444 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
How many LMI types are available on Cisco routers? A.) Four B.) Two C.) Five D.) Three
Identify the 2 methods to modify the routers boot sequence? A.) Setup program B.) Boot system commands C.) RXBoot D.) Config-register
What is passive topology in ccna?
Which of the following is not a characteristic of link-state routing protocols? ❍ A. VLSM support ❍ B. Route summarization at any bit level ❍ C. Full routing updates at regular intervals ❍ D. Discontiguous network support
Identify the command to display the IP routing table? A.) show route B.) show ip route C.) show ip table route D.) show ipx route
What is true about Link-State protocols? A.) They maintain a more complex table than distant vector protocols B.) They maintain a less complex table than distant vector protocols C.) They use routing ports D.) The maintain backup copies of the IOS
Define class full protocol?
What is a switch and why we are using switches?
What key do you use to view the last command? A.) Left Arrow B.) Space Bar C.) Up Arrow D.) Right Arrow
What is the maximum request timer?
What does -1 mean in an extended IPX access-list? A.) Any IP address B.) Deny all C.) Deny host D.) Any host or any network
Identify the command that specifies Serial 0 in slot 1? A.) Router(config)# interface serial1/1 B.) Router(config)# interface serial1/0 C.) Router(config)# interface serial0.1 D.) Router(config)# interface serial0/1
CCNA 
