X.25 is characterized by layer 2 identifiers, and what else?
A.) Virtual Lan's
B.) Session Layer
C.) Transport Layer
D.) Routing Updates
E.) PVC's
- 1 Answers
- 3434 Views
- I also Faced
- E-Mail Answers
Answer / guest
Answer: E
Permanent Virtual Circuits and Layer 2 identifies are
typical in X.25.
| Is This Answer Correct ? | 1 Yes | 0 No |
What is the difference between switch and hub?
Which OSI layer end to end communication, segmentation and re-assembly? A.) Network B.) Transport C.) Physical D.) Application E.) Data-Link F.) Presentation
Extended IP access-lists (100-199) can be used to control traffic. Which command listed below will permit smtp mail to only host 3.4.5.6 ? A.) It is not possible for SMTP traffic B.) access-list 102 permit tcp any host 3.4.5.6 eq smtp C.) access-list 101 permit tcp any 3.4.5.6 0.0.0.0 eq 23 D.) access-list 102 permit tcp any any eq smtp E.) access-list 101 permit tcp any 3.4.5.6 0.0.0.0 eq 25
How often does IP RIP send out routing table updates by default? A.) They send complete updates every 30 seconds B.) They send partial updates every 30 seconds C.) They send complete updates every 60 seconds D.) They send partial updates every 60 seconds
Identify the command to display the hardware platform information? A.) show all B.) show platform C.) display hardware D.) show version
Identify the 3 pieces of hardware you would not install to prevent broadcasts? A.) Switch B.) Repeater C.) Bridge D.) Router
hi friend i hav difficulty n need to solve it...v need to implement a new raw switch in company as to increase the no of staff...snc raw switch by default is in server mode,i wanna know 1.how to make a switch in client mode...2.how to configure switch i mean to sy how to connect all switches to network.
Explain the difference between igp and eigrp?
What is the mesh network?
Which type of switching reads just the address portion of the frame and then immediately starts forwarding it? A.) Cut-Through B.) Store-and-Forward C.) Tabling D.) Routing E.) Inverse ARP F.) Fast Forward
What is the purpose of the DLCI? A.) Identifies the remote routers B.) Contained with a 802.2 frame for routing purposes C.) Used with PPP during authentication D.) Identifies the PVC in a Frame Relay network
What utility can you use to see the path a packet takes through an internetwork? A.) Route B.) SNMP C.) Trace D.) Ping
CCNA 
