Interested to Buy Any Domain ? << Click Here >> for more details...
Which of the following encapsulation types can be used on
leased-line connections? (Choose two)
❍ A. HDLC
❍ B. Frame Relay
❍ C. ISDN
❍ D. PPP
- 10 Answers
- 13372 Views
- Wipro, I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / jitendera kuamr sinha{network
Hi ZaYanQ
these problems are really a good stuff but i want to say
that if you are going to place any question on that site
plesase wait for at least 20 visit if in 20 visit no one is
providing answer then you can plase your answer here.
Please take it as a request.
Thank you
Jitendera kumar sinha
| Is This Answer Correct ? | 2 Yes | 5 No |
in the ospf area network dr and bdr selection procedure occur let there are 4 router in that n/w r1 have the higher priority then r2 and r2 have higher priority then r3 and so on like that r1>r2>r3>r4 now as we know that selection of dr and bdr based upon the router priority so in this case r1 will be dr and r2 will be bdr now my question is that if i am going to implement 5th router which have greater priority then r1 then will it become dr atomically remember that i am not going change my 5 or 1st router property answer that one please
Identify the purpose of the Ping command? A.) Share routing information with a neighbor router B.) Transmit user data when buffers are full C.) Test connectivity at layer 3 D.) Test entire protocol stack
When you use the Cisco IOS command show configuration on a router which part of the output shows the specific conferred IP addresses and shored masks? A. the IP host table B. the interfaces output C. each section of the output D. the global configuration statements E. the section under the autonomous system number
What route entry will be assigned to dead or invalid route in case of RIP?
What is the function of Layer 2 Switch?
What is the Network Layer of the OSI responsible for? A.) Bridging B.) Routing packets through an internetwork C.) Regenerating the digital signal D.) Gateway services
On which base distance vector choose best path?
Identify 3 characteristics of ISDN? A.) Transports voice and data B.) Transports voice only C.) Support both BRI and PRI D.) Runs over existing phone lines E.) Same as X.25
What is raid in ccna?
What type of Ethernet operation allows only one entity to transmit at a time? For example, if someone else is transmitting, they must wait. A.) Full-Duplex B.) Dual-Duplex C.) Half-Duplex D.) Latex E.) Quarter-Duplex F.) Suplex
hello sir , if i finish this certification is the job is conform ?? and in chennai were i can do this ??
Why twist in twisted pairs?
CCNA 
