Interested to Buy Any Domain ? << Click Here >> for more details...
What are blocks in ios?
What is full join?
Mention how validation activities should be conducted?
Where can I find my windows 7 product key?
Explain how can we measure the performance of an ip link?
Explain your project of banking domian.
Explain about party and customer in ar : oracle accounts receivable
what is pre settlements and post settlements in Derivatives?
What is the mean of chipped tooth?
Why do we need Sessions?
What is cascadetype in hibernate annotations?
What is the importance of implementing a fault tolerance system? Are there limitations?
How do I install php?
How to look up a Service by Port and Protocol?
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
