Answer / chinmay kumar patra(npti)

no its not bad otherwise this enthalpy will loss at condenser.by doing this we r increasing cycle efficiency by keeping system heat within system.

Answer / hridesh singh, npti

No it is not at all bad as the bleeding of steam is necessary from the stages of turbine as it ensures that the tubes of reheater does not get ruptured due to their position in the boiler at a very hot zone.

By seeing a Power house Can we justify the kV of that power house?

1 Answers  

---

transformer shut down process.

0 Answers  

---

What is df/dt protection?, How to calculate setting range of 30 MW steam generator???

1 Answers   DS Sugars, MEMF,

---

why high pressure heater will take after sufficient pressure? what happen when high pressure heater will take from COLD REHEAT line at light up time when hp and lp by pass in service.(means can we heater take at low pressure?)

2 Answers  

---

During shutdown of Steam Turbine,How do we cross the critical speed?

7 Answers   OPG, Power,

---

What is A.T.T.?

4 Answers  

---

How to calculate power press toneage

0 Answers  

---

How do you consider that you can improve and what assistance do you need to achieve this

0 Answers  

---

Is it not bad to bleed steam from turbine stages before utilizing its energy.

2 Answers  

---

Where is the pressure reduce valve in the power plant

6 Answers   Grasim,

---

what is scanner air fan & how dose it work & is there any interlock in power plant

3 Answers   APGenco,

---

Can any one advised me how we can measure the losses in a 11kV/415v power transformer? We have no access to the incoming mains into the primary of the transformer. Can one derive something useful by measuring temperature rise in the transformer?

1 Answers   Dexdyne,

---