where we use stardelta starter and dol starter

Question Posted / anilnandyala

4 Answers
17046 Views
HCL, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

where we use stardelta starter and dol starter..

both are use in motor ,The purpose of stardelta starter is
to limit the starting current of motor.If the starting
current is low means we can use dol starter upto 5 hp
motor.above 5 hp motor we should use stardelta starter for
limit the starting current.

Is This Answer Correct ?

43 Yes

4 No

where we use stardelta starter and dol starter..

Answer / nimish

where rating of motor is below 5 h.p. normally D.O.L.
starter is used and above that star delta starter is used to
limit the starting current.

Is This Answer Correct ?

14 Yes

0 No

where we use stardelta starter and dol starter..

Answer / nagaraj n salimani

DOL starters are used when motors are below 3.5Kw and if you
go above 3.5 Kw then we have to go for star delta connection.

Is This Answer Correct ?

12 Yes

12 No

where we use stardelta starter and dol starter..

Answer / simon peter

Star delta r used in more than 3hp ,3phase squrrel cage induction motor & DOL 3 to 5 hp single squrrel cage motor.....

Is This Answer Correct ?

1 Yes

4 No

Post New Answer

More Electrical Engineering Interview Questions

What is accuracy of a measurement?

0 Answers

how ELCB drip when earth and phase touch together?

2 Answers

How can i calculate heat load ?

3 Answers DSSR, NSN,

Is current scalar or vector?

11 Answers

Short circuit current of 2500 KVA 11/0.415 KV transformer both Secondary and primary side. best regards. Ali

1 Answers

what is the effect of earth on capacitance in 3-phase and 1- phase transmission line?

0 Answers

I have 11KV/415V power distribution transformer. I have found unbalance current in LT (415V) side. Also observed that unbalance voltage (3V) at LV side due to HV side unbalance voltage. What should I check for this? Also, the same LV side load can run in balance on captive power.

1 Answers

whycircuit breaker is not connected at the generator end where the capacity of the generator is more say 60MW, 100MW etc.

2 Answers Adani, Adani Power,

What is Auto Mains Failure Panel & Auto Synchronizing Panel

0 Answers

what is the purpose of battery tap voltage.

3 Answers ABB, Crompton Greaves,

In parallel operation time both NGR’s close or not close if both close what will happen

0 Answers

How can we calculate the cable size??? plz give the formula !!!!!

3 Answers

For more Electrical Engineering Interview Questions Click Here