Why we choose 400kv,220kv,132kv,66kv,33kv transmission
voltages for transmitting power. Why not other voltage
levels.
Answers were Sorted based on User's Feedback
Answer / ss
6.6kv and 11kv are generating voltage............nowadays
765kv also transmission voltage
Is This Answer Correct ? | 25 Yes | 79 No |
how to calculate the starting current of a motor? gopal
What are steps to be taken while designing of DYN11 distribution transformer to achieve magnetising balance?
How to select AC3 duty contactor for DOL & Star-Delta starters
How to calculat the size of copper& aluminium wire ?
what is anti-pumping relay and the significance of it in a switcgear cb control system?
what is reverse power relay brief explanation and in b/w where it is connected
explain the process of commutation in a dc machine. Explain what are inter-poles and why they are required in a dc machine.
why to use 50hz only in tansmisson and as well as in distribution why not60hz?
what is function of reactor coil in Power factor correction panel
I have a question, I visit 01 site and face a problem, there is 2.5 ton Air Con working, when air con compressor is running at that time rectifier voltages are increasing upto 290-295 v and rectifier is giving main high alarm (rectifier is APC single phase), before starting compressor rectifier voltages was 230v. when air con is going off rectifier voltages are decreasing smoothly at its actual voltages 230v. Load on Genset phases is this: Red-13.5 amp AC (Air Con load), Yellow-1.7 amp AC (BTS lights etc.) and Blew-4 amp AC (telecom system load), Genset phase to phase and neutral to phase voltages are also ok. These are 10 sites having same system and same rectifier APC brand at every site 02 genset are working but the problem is same at all these 10 sites. What will be the reason behind???
1.What is effect of capitance in transmission line? 2. After raising the voltage at receiving end what will be happen? 3.how we nullify or control the raised voltage at receiving end?
why surge protectetor work explain with the help of circut diagram?