Answer / aftab ahmed mazari

Single Acting means, in one direction,(Open or close) the
valve will move with signal and other direction will move
with spring force.
Double Acting means, valve will move (Open or close) in
both directions with signals.
aftabmazari@yahoo.com

How RAL(Rotary air lock)works in cement industry?

0 Answers   Jaypee,

---

Why do we use triad cable for RTD to Temp.transmitter connection? Why we don't use 3 core cable?

1 Answers   Process Control Technologies,

---

what is the advantage of submersible level transmitter compare to ultrasonic level transmitter?

0 Answers  

---

I have a problem with a valve (air to close). When it is fully closed and try to open 1% it doesn't responce till 3% open suddenly more than 3% then back to 3%. I tried to tune positioner then removed it, the problem still exist. Any idea

3 Answers  

---

Can I put my meter across an RTD to check it safely witout tripping the equipment when it is connected to an monitoring device eg.RTD module or IQ 1000

1 Answers  

---

what is the difference between auto tuning and manual tuning of controllers(eg:PID,PI,PD CONTROLLERS )

2 Answers   GATE,

---

1. What means HART communicator / where it is used / how to use it? 2. Types of Thermocouples and its temperature ranges / output of thermocouple? 3. Types of RTDs and its temperature ranges / output of RTD? 4. Idea about Temperature Transmitters? 5. Difference between Analog and Digital signals? 6. Difference between “2 wire” and “4 wire” system / instruments? 7. Difference between “Potential” and “Potential free” contact? 8. Types of flow meters / transmitters? 9. Types of level transmitters? 10. Difference between “Power/Control” cable and “Instrument” cable? 11. What means “shield” and “screen” in cables / how it is useful? 12. Draw a schematic of closed loop circuit of flow / level / pressure / temperature? 13. Idea about calibration of Control valve / positioned / I/P? 14. How to bypass a digital/analog signal in PLC/DCS by hardwire and software?

6 Answers   JSL,

---

Explain the difference between differial pressure & delta pressure?

1 Answers  

---

how u measure flow?orifice measurement?why all ft in square root?

1 Answers  

---

How much should be the values and/or percentages of these given below factors for a good controller ? Steady state error Delay Rise Time Overshoot Peak Time Settling Time Damping Oscillations & vibrations thanks

1 Answers  

---

Why plc require in analog input 4-20amp & 0-10 volt?

0 Answers  

---

how to make a calliberation for deffirential pressure

3 Answers  

---