on which principle control valve works?

Question Posted / deepak naik

3 Answers
10262 Views
Lupin, Reliance, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

on which principle control valve works?..

Answer / manoj

force balance

Is This Answer Correct ?

36 Yes

4 No

on which principle control valve works?..

Answer / anadi

following is the principle and statement==
Mechanical force due to actuator spring is overcome by
pneumatic force.

Is This Answer Correct ?

5 Yes

0 No

on which principle control valve works?..

Answer / k.ravi kumar

Force per unit area in the actuator

Is This Answer Correct ?

13 Yes

9 No

Post New Answer

More Instrumentation Interview Questions

in the construction field why hook up s.s.tubing for transmitter using upto 6mtrs of closed loop, but y not open loop nomore restriction

5 Answers Sabic,

LADDER LOGIC Can any body state Logic on following condition Instructions to use 1-XIC 2-XIO 3-Output ONLY Program Push 1st button On - 1st lamp should On Then Push 1st button Off - 1st Lamp Should remain on Push 2nd button On - 1st lamp should Off and 2nd lamp should On Then Push 2nd button Off - 2nd Lamp Should remain on.

4 Answers

If a transmitter is installed 10 m below its tapping point how much pressure exerted if fluid is water?

10 Answers QAFCO,

installation process of orifice,a question asked for confusion creation in interview by BARC 1.if orifice is tightly fitted with pipe ,it will act like venturi 2.if orifice is left hanging in between liquid it will not create the pressure difference exactly,

0 Answers BARC,

Hi, Is there any smart plant instrumentation design training institute in Bangalore?

0 Answers

What is the minimum rating availalbe for weld neck orifice in market?

0 Answers Jindal,

How can we calibrate the level interface for Fisher® FIELDVUE® DLC3000?if use water to calibrate and our liquid SG are 0.75 and 1 ,Displacer height=14" and How much should be set SG in trasmitter during calibrate,for URV and LRV how shold be set

1 Answers

why we take %i0.0 as input for twido plc

0 Answers

how to calculate the temp. of RTD&Thermocouple when we got some mV r Ohms?if anybody has d chart pls mail the chatrs to me...

1 Answers

How to check range of DP Transmitter

7 Answers

What is the difference between fiber optic cable & Ethernet cable

2 Answers BEMCO, CCC, Pidilite,

i have been asked by QAFCO to appear for interview for thy post of Instrument Designer(INTOOLS)..i m engineering graduate with 5 years exp. in design engineering.Will this job profile suit me??i need all ur help n suggestions for thy same?

0 Answers QAFCO,

For more Instrumentation Interview Questions Click Here