Answer / sagar upadhyay

If we connect an equipment that demands a high current
( offers a low resistance), then we call it a large load.
Similarly, equipment having large resistance will be called
as a small load. As the load changes, the load current
supplied by he gen also changes. It depends on the type of
gen. how it behaves in such cases. But generally the voltage
drop will reduce if the load is increased until & unless the
prime mover input to the gen is not increased.

Answer / k.prakashchandra

In case of single gen ,increase in load causes decrease in
speed . Then governor of the prime mover makes the engine to
draw more fuel to maintain the speed.

Give the expression for the frequency of oscillations in an op-amp sine wave oscillator?

0 Answers  

---

What is the difference between Ceiling Fan armature and Tablefan Armature or winding.

5 Answers   Pricol,

---

sir what is the minimun earth resistance value of an industial bit and grid bit ? and Why?

1 Answers   Kirloskar,

---

why synchronization done in clockwise direction?

12 Answers   Hindalco, NTPC,

---

What is marx circuit?

0 Answers  

---

how can calculated the rating of the 11 KV transformer?

6 Answers   NBCC,

---

how "rabbit ACSR" conductors are more efficient than "weasel ACSR" conductors

1 Answers   AITM,

---

A 6.6 KV motor breaker is try to Drack OUT by me while the motor running. What will Happened? a, will Trip. b,Drack Out lever will not access c, will get shock d, noting will happened

4 Answers  

---

Is it mandatory statutory requirement of transformer oil filtration annualy despite oil is withstanding required dieelectrical strenth and all others parameters

5 Answers  

---

what is significance of B-H curve? how it differs form ordinary transformers to Amorphous Transformer?

2 Answers   BARC,

---

what is direct dischage of power transformer

1 Answers  

---

Why is remote backup preferred to local backup?

0 Answers  

---