Is your generator is automated or manual if so do you know
the circuits?
- 7 Answers
- 20843 Views
- RRB, I also Faced
- E-Mail Answers
Answer Posted / ponvel
manual
| Is This Answer Correct ? | 2 Yes | 5 No |
Post New Answer View All Answers
hi everybody how to design string combiner box (scb) internal parameters like bus bar and spd (surge protection device and fuse which place to set that,and also bus bar one particular cross sectional how much heat generated and how much power loss tell me Clearly and briefly
use of PIR in ehv breaker
What is CCM in Electrical ? where can we use this material?
The series field winding has low resistance while the shunt field winding has high resistance. Why?
According to underground cables a) stress b/w sheath & conductor is high b) inrush of core & conductor
How will you justify IR value and Charging voltage of any motor,transformer and Cables.......???? . . . . . . . . Plz tell me any body Baljeet Singh, engineer_89@refiff.com
What is Annunciation?
How do I calculate/select Droop CT ratio for various capacity of generators?
what is the meaning of 5% droop or 7% droop in AVR?
What are the necessary components of the feedback control system?
how could we calculate the no of outgoings from a 800 watt distribution board
what is the difference between fault current ant short circuit current?
I completed iti in2004 I was worked in A grade contractor can I get c licence
How to check the cable fault / hv test of transformer cable.
I have a current transformer with 1 main reading meter with transformer outside the building and a control panel having 5 CT reading meters with black round coils inside the building. I want to know, A) when current pass through the Transformers, will the current be reduced or be the same and after that B) when current pass through the CT meters with black round coils, will the current be reduced or be the same. C) in the above process will the reading of the main meter be same or different, from the total reading of all the 5 CT meters.
