Interested to Buy Any Domain ? << Click Here >> for more details...
Why TAP changer provided in primary side of HT
transformer ? and why not in secondary?
- 9 Answers
- 49174 Views
- ABB, Reliance, I also Faced
- E-Mail Answers
Answer Posted / naaz
Because of in HT side voltage is large and current are less and chances of sparking are less that's why we provide tap changer in primary side
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
How to calculate the multiplying factor for energy meter with ct ratio given
tan delta equation test on alternators
size of condotory fron voltage level
Phase control and integral control are used for?
v/f drive basic princeple
what is gas turbine intercooling ?
what is the meaning of WYE and DELTA in Electric meter?
Can u Explain about the electronic trivector meter and the use of data converters in them?
Brushes are placed at magnetically neutral axis,when brushes reach that point,the armature conductor gets shorted,but it can be seen that the dc supply is also shorted,wont that get damage? help me plz
Minimum IR value of 1.1 kv grade 3.5c (300, 240,185,150,120,95,70,50,35,25) sqmm Aluminium XLPE cable and 4c (16, 10,6 & 4) sqmm cu arm cable between RY,YB,BR,RN,YN,BN,RE,YE,BE & NE.
If a shunt Dynamo has induced emf 100V and 0.4 ohm resistance and battery of accumulator of open circuit emf 110V and 0.5 Ohm resistance are in parallel what is common terminal potential difference?
How to calculate the fuel consumption for 600kva DG genset which connecting with 25%load?
What are the different methodes for calculating the short circuit Current?
Does all the output contacts (N/O as well as N/C) of a Numerical relay operate when relay receives a binary input/inputs or contacts are designated to specific logic input/inputs and only these contacts operate?
What is the general system requirement of alternator?
