Convert a pressure, level, flow, or temperature process
variable value into the appropriate pneumatic or electrical
value given different types of instruments.
- 6 Answers
- 19862 Views
- Jindal, MCL, Thermax, I also Faced
- E-Mail Answers
Answer Posted / jadhavamit
You can use pressure switch for pressure indication,
for level u can use DPT
for flow u can use mass flow meter/turbine flow meter/magnetic flow meter/ultrasonic flow meter
and for temperature u can use RTD/Thermocouple.
keep in mind 1 note that every transmitter output is 4-20mAh these is read by every controller and switch output is in form of 1 or 0, means 1 high to its set point and 0 below setpoint.
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
What is the purpose of bypass valve across AS valve.
What is the use of single seated valve?
What are the interlocks we have to check during the start up of LP/HP compressor?
What is the use of temperature compensation?
What is cut off relay? And why use in PLC and DCS?
What is compensation for flow ? Why we use compensation ? What are the factors of different compensation ? We not use then what problems may happen ?
Why ac supply load cell is used? Can we use the dc supply load cell?
selection of the zener barrier for the hazardeous area zone 0
Please can anybody help for control valve sizing step by step procedure?
I am manjunath having exp in maintenance of chemical plants,know i want to do a design course INTOOLS,after doing design course can we get jobs in design field.sinve i dont have design exp..
Instrumentation symbols interpration, P& ID, Logic diagram analysis, Electrical drawing analysis.
How to calibration a control valve?
how to convert cubic metre per hour to newton cubic metre per hour
Sir , i have completed my M.Sc In Instrumentation and presently working in Maintenance department 3 yrs Exp , is there is any possible for work in offshore ..
Tr. Wiring for calibration.
