Answer Posted / anuj singh
First of all take a multimeter and set in resistance mode and measure if value is near 100 for pt/RTD at room temperature if value is nea zero then RTD is damage.
Is This Answer Correct ? | 16 Yes | 0 No |
Post New Answer View All Answers
which type of zones used for boiler? & why ?
What is hp & mp seperator .& what is its working principle ?
why we are not using the turbine flow meter in the steam service?
in sulfur process what is material of impulse line we use to connect with transmitter ? and does teflon affected by sulfur?
How to calibrate Toxic gas detector?
why we use 3 wire rtd direct wiring for temperature measurement instead of temperature transmitter like bearing temperature
hi! i want to know about mpse exam.
If relative y axis vibration sensor is by passed, and relative x axis and absolute sensor is left working. how much monitoring i would have risked?
kindly sent some demo question and answer
In VVVF DRIVES VOLTAGE IS ALSO VARY WITH THE FREQUENCY. HOW? WHAT IS THE DIRECT FORMULA RELATING THESE TWO.
why use 50% lel methane gas concentration for gas detector calibration instead of 60% lel gas concentration whereas the hi alarm set at 60% lel.
What are the interlocks we have to check during the start up of LP/HP compressor?
Explain the key components of control loop?
i want to know the interview format fot gail, instrumentation. pls answer me in habib.sami1003@gmail.com
what is a half wave, full wave, and bridge rectifer.