Difference between directional earth fault and
non-directional earth fault
Answer Posted / manesh s
Directional Earth Fault is the Fault(between Phase/s to
Earth)in the system,if system is using only one source, so
Fault would be in one direction(towards the system)
where as Non-Directional Earth Fault is the
Fault(between Phase/s to Earth)in the system,if system is
using two or more source, so Fault would be in two
direction(away or towards)
Is This Answer Correct ? | 9 Yes | 4 No |
Post New Answer View All Answers
We have Demin Closed cooling water system with expansion tank for cooling oil system. Expansion tank having N2 bladder. Whenever N2 bladder bursts out, Closed cooling water circuit pressure drops and make-up happening, eventhough there is no leaks. And how Circuit pressure drops?
im try to calculating seawater flow required for SW-FGD system. I need a guide, equation or method to do it, can some one help me! Thanks very much
what is the trip circuit supervision in an electrical meaning?
How do you consider that you can improve and what assistance do you need to achieve this
How to calculate boiler capacity? I have 1 Autoclave, Which has to use for AAC block. Dimension for this Autoclave is - 13 Meter Length & 2.2 Meter Diameter.
operation
What is LB-SR.
What is surging in a centrifugal compressor ? How it occur's ? How is antisurging done ?
some one can tell me how residual type excitation is provided through transformers to an AC generator without any battery or PMG&excitor
procedure of how to generate power in solar plant.
what's the moog valve
why airtel use + 24 volts and other operators use -48 volt
DCS marshaling Cabinet Power supply can be replace during plant running time? Answer Yes it is possible. I am talking about the controller and cards power supply modules. They are always redundant and connected through diode so that if one power supply fails the other can take the charge immediately.so it is possible to replace one of them in running plant if the other one is healthy. MY question is how switching done.
Why superheated are started before I'd and rd fan?
Which will have more strain energy 1.Spring 2.Circular disc 3.Solid square plate.