Generally in which location ( JB or IO card or DCS) the
thermocouple compensation is done.Also where they measure
the atmosphere temp ( for compensation) in JB OR DCS panel?
How they compensating that atmosphere temp? is any circuit
for that ( like in rtd wheatstone bridge)?
Answer Posted / phani
the cable termination for the thermocouple is thermocouple-JB-temp transmitter-IO cord(DCS),in this cable termination compensation ll be done in JB only.
Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
What is standard of DCS panel design?and what is step of DCS panel design?wiring and type of connector(screw or DB connector)
Any one can help me to identified, how can we interchange the device in FF
how many types of spped sensors n vibration sensors?their basic principle n connection?
Please can anybody help for control valve sizing step by step procedure?
I faced several time siemens ps2 positioner automatically getting Chang in it's set point direction after auto calibration So is there any causes biside this or any permissives ?
What are the interlocks we have to check during the start up of LP/HP compressor?
how to calculate orifice sizing? and tell me if pipe size bet 50mm t0 200mm then we can use pipe flange??? and above 250mm pipe size should i use D & D/2 Flange? is it right or wrong?
Why all the drains(Gland sealing,ESV,Casing inlet etc) are directly connected to the flash tank instead of hotwell of the condensor in the power plant? My Email Id:naba02222@gmail.com
What is the diffrence between ff tx and non ff tx
Explain PID, ON/OFF, Controls
How the warning lamp of a charging-system is activated ?
what is isloted barrier how it works and what are the main purpose.how it make safe area.
how pressurize drum calibrated ?
How do you identify between actual alarm and false alarm in a Temperature Transmitter in SCADA based Control System
What is the difference between uv and ir scanners? and what is the workig principle of both