In a class of 150 students, 40 passed in Social Studies, 90
passed in Science and 30 failed in both the subjects.
vi)How many students passed in at most one subject among
Science and Social Science?
Answer Posted / amar
105
Is This Answer Correct ? | 4 Yes | 15 No |
Post New Answer View All Answers
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
what is the difference between scaler and vector drive
I was working on calibrating turbidity transmitters endress+hauser at effluent polishing plant.We calibrated using NTU buffers.What happened is that when we immersed the sensor, everytime we raise and lower the sensor gradually, the reading will vary.my question is that is there any specifications on what is the required distance from the bottom of the container with buffer to the face of the sensor?Is it ok to install the sensor in a medium which has turbulence specially if bubbles are present?
Please tell me details about Sox,Nox,SWAS analyser????
What is rang ability?
Explain operation of Haskel pump.
I want to measure and control level in tank of size 10*5 filled with gasoline, so plz give me the solution with clear details. how to select transmitter and sensors.
Explain the working of an enraf level gauge.
How u will setup SPI(2007) on Citrix Server (Thin Client Mode)? Plz Justify?
what is a good line as ic engineer as maintenance ,oc, project, calibration ,validation engineer?
How to work temperature gauge?
what is the vital subject for scoring bhel exam&what is the question pattern
I have a Control VAlve having size of 2 ".Only the known parameter is Pressure drop . Its 2 Kg. Then How to calculate control valve sizing means Cv.
What is the constant voltage unit?
Tell about your IFFCO plant visit.