Interested to Buy Any Domain ? << Click Here >> for more details...
Why we Specify Transformer rating 433 V Instead of 415V
?
- 8 Answers
- 38636 Views
- ABB, ERA, Uddans, I also Faced
- E-Mail Answers
Answer Posted / ash
433V is the no load voltage. that is when the transformer
is supplied at its HT side but without any load connected
to the LV side.
| Is This Answer Correct ? | 18 Yes | 6 No |
Post New Answer View All Answers
Is the installation of the filter cloths necessary before spreading the gravels at the transformer yards?
What is the use of lag compensator?
if sf6 gas low in gis what will happen
what are the pecularity of shaver sockets ?
defult setting in p220 micom motor proction relay for 11kv,640kw,f.l.a.-40a,1440rpm ht motor?
what is the relation between reactive power and power factor for the what is the limit of reactive power and power factor
what is the difference b/w pvc cu conductor and cu breaded wire..?
What are factors to be considered while we selecting the Core Balance Current Transformer for Earth fault protection
what is servo motor and how to work it.
in cvt,there are two windings,1a,1n and 2a,2n.in my one project i use only one winding i.e.1a,1n. the other winding is not in use, so i connect it in open delta and want to close it by ibsertibg thermal resistor. the output of cvt is 132kv/115/sqrt3. plesae tell me exact value of resistor, so i may close it to avoid the resonance phenomenin. send me answer on this email adress please. aetcon-po@aetcon.com
What are the uses of stepper motor?
how to produsing geretor power
71ohm,111ohm,95ohm,179ohm in calculate the total ohm in series circuit
CAN ANYBODY PLEASE TELL ME HOW TO DESIGN A SERIES REACTOR FOR LIMITING SHORT CIRCUIT FAULT CURRENT??
how many load we can take for lighting
