Answer Posted / krishnan
There are two ways... we can either go for gear cutting or gear manufacturing ... gear cutting can be done by milling etc whereas gear manufacturing is done by special machines like gear shaper or gear hobber ...
Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
Explain the difference between “stress and strain”?
How to find the amount of natural gas required to produce 1kwhr of energy?
pls ,send me technical questions of jindal steels and power ltd
What is the boiler bank position?
What are the defects in exhaust valve?
Explain how do concrete pumps work?
Study the attached ACS 790 AHU and boiler GUI and refer to the video on the software usage, catalog and the step by step document (page 9) to perform the following task: List in a table form the controllers and all their connected I/O for the boiler and the AHU.
What are the causes of I.O. high temperature in a diesel engine?
how the material no. 2062 will mild steel of desity 7.85? what are the other codes?
Which are the sheets of metals?
Dear Sir, Please send me the questions frequently asked during bhel persoal interview for supervisor trainee With worm regards, Alok Kumar Rout e-mail id- rjdalok22@gmail.com
what are various part found in vapour absorption machine and its working
Hi! Greetings of the day. Can somebody tell me about as built duct sheet area calculation method. As we know that for this purpose A = (W+H)*2*L. But I have query about multiplication factors for elbows, tappers, offsets etc if there is any. Also refer the papers if available. Please revert. Thanks in advance.
How does hydraulic clutches work?
Hello sir! I hav read the above discussions about PSU.I hav 72% aggregate in Mechanical bt i do had a back in 1 subject,so m i too eligible for PSU?