1 no. 22 kV feeder is taken from state electricity board.
350 MVA is the S.C. MVA.
now i am feeding this feeder to HT Panel having 2 outgoings
which further supply to 2 Transformers.
Can you please suggest me the type & rating of cables
are 3 of these cables same?
or they are different?
please help...............
- 2 Answers
- 5606 Views
- TCE, I also Faced
- E-Mail Answers
Answer Posted / latesh patel
2 Runs of 300 Sq.mm. cable will be sufficient for the 22KV
side incoming and the same will at outgoin side
irrespective of load connectd till the voltage level
changes to till lower 11 kv or 415 means txr should come in
picture...
| Is This Answer Correct ? | 2 Yes | 2 No |
Post New Answer View All Answers
Is it possible to use a S1 duty class motor for crane application (S4)? If not, why?
Give two basic speed control scheme of dc shunt motor?
Explain the laying procedure and laying depth of submarine/subsea power cable for 220/400KV system? Also available cable diameter?
How should i design a 1ph & 3 ph transformer. Kindly let meknow all steps and formulaes related to design from scratch.
2. What are the parameters of EHT sub-station?
why we have to particulary use ACB for below ratings,even available of MCB,MCCB with that range ?
Grid fault level [KA]?
What shall be the secondary output voltage if the primary winding of a 220/6V, 50 Hz transformer is energized by an 110V, 60 Hz supply?
why and how voltage sharing in transformer, during magnetic balance test ?
What Maximam Gap Taibaar & Bush
What is the difference between diesel generator engine with and without turbo charger with the same capacity?
why the protection turbo generators is most complex?
Explain the working of variable frequency transformer?
Swg formulae
take 100kva DTR( delta/wye ), what ll happen if we connect 11kv to LT side instead of connecting to HT side? will the DTR behave as a step up transformer or something else????
