Answer Posted / rishit
yes,
if we hold a shaft of motor and try to rotate it if it will
easily rotate without any sound, problem then it is ok and
and if it not then it needs a little adjustment on both of
its side
| Is This Answer Correct ? | 11 Yes | 4 No |
Post New Answer View All Answers
WHAT IS THE USE OF PIG TAIL IN WINDOW CT ?
Hi all I had applied for the RRB test in the ELECRICAL category. I would be pleased if any of you can sent me previous year question papers. Please forward the question papers to varshashahi@yahoo.com Thanks and regards Varsha
FEINGING DECREASES THE FLUX DENSITY IN THE AIR GAP. HOW?
why high speed tripping relay will be used in tripping circuit why not normal relay
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
What is the high series capacitance winding on high voltage power transformer ?
concept of busbar and load dispatching..?
What size cable (based on voltage drop) is required to supply a 40 A three phase boiler if the wiring system is 75V single insulated cables installed in non-metallic rigid conduit 56m from the main switchboard? Voltage drop in the consumer's mains is 8V.
What is a differential amplifier?
what is the difference between single ratio, multiple core and multiple ratio, multiple core ? please explain.
am commissioning the trafo without connecting the neutral therefore unbalance will occur what is the alternative solution for this?
WHATIS TIME CONSTANT? WHATIS ITS SIGNIFICANCE? ILLUSTRATE THROUGH EXAMLES.
what is the difference between rectifier and converter and commudator?
any body,pls tell me how to done relay coordination ? how to coordinate by TCC curve?how to read the tcc curve?
what is the Pickup/drop off ratio in BCPU relays
