Answer Posted / k k rameshkumar
DCS means Distributed Control System. In this the
controllers/control are physically/geographically
distributed. For overall control, all the controllers are
exchanging signals in unison with the supervisory controller
(Normally the Main CPU) to control the whole system.
Generally it is a PC based control system
| Is This Answer Correct ? | 64 Yes | 8 No |
Post New Answer View All Answers
Coal mill Instruments Equipments for cement plant And process diagram ?
How to convert milliampares into flow??
How many types of sensor
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
please tel me the calibration of pneumatic controler.
Identification of ss fittings, pilot valves, relief valve.
can we copy the software from a transmitter using hht(hart 275) ?
How to calibrate H2s Dectector
What is three element in drum level?
What is PDS and PDMS ?
If a warning lamp will operate with the ground circuit is bypassed with a jumper wire to ground, what should you check?
how to calibrate electro pneumatic positioner 8013 mil controls ltd ?gsr
What is force balance principle?
what is the difference between profibus and controlnet networking.
I m appointed as an automation trainee engineer in small firm in that I am only the one , my company give me a project on s7-200 as i m beginner I don't know how to program so please send me the helpful site so that I complete my project before deadline....please help me out in this critical situation.
